|Nominal duration||4 years (45 ECTS)|
|Awards||PhD (Doctor of Philosophy (Ph.D.) in Technical Science)|
|Tuition fee||To be confirmed|
|Application fee||€20.00 one-time
For participants outside the EU/EFTA studying on terms applicable to foreigners.
Note 1: Citizens of Armenia, Azerbaijan, Belarus, Estonia, Georgia, Kazakhstan, Kyrgyzstan, Lithuania, Latvia, Moldova, Russia, Tajikistan, Turkmenistan, Ukraine and Uzbekistan, i.e. the countries of former USSR, are permitted to apply for Polish Card (the Card of the Pole), which entitles its holders to choose whether they wish to study on the terms applicable to Polish nationals (no tuition fees for full-time studies) or those applicable to foreigners (tuition fees applicable). If you choose terms applicable to Polish nationals, to become an applicant please visit rekrutacja.pg.gda.pl/. Dream Apply platform is used for non-EU/EFTA citizens studying on terms applicable to foreigners only.
Note 2: Foreigners granted a residence permit (to settle in Poland) or an EU longterm residence permit, those granted temporary or complementary protection in the territory of the Republic of Poland or with a refugee status granted by the Republic of Poland, despite being non-UE/EFTA citizens, study on terms applicable to Polish nationals (no tuition fees for full-time studies).
For more details please visit: pg.edu.pl/international/admission .
Postgraduate diploma (or higher)
- MSc (or equivalent) degree confirming completion of 2nd / long cycle (graduate) studies.
There are 4 steps of applying for a PhD programme. For details please visit our website: Admission to PhD studies.
NB. STEP 1 is performed ouside Dream Apply platform and is neccesary to complete to proceed further.
STEP 2: Upon receipt of an Approval Letter from a prospective research supervisor, registration at DREAM APPLY platform and applying for a chosen PhD programme, filling in an on-line application form and uploading scans of your documents:
STEP 3: Upon participation in an interview and receipt of Offer Letter (not issued for EU/EFTA citizens), scan and upload to your application the following documents:
STEP 4: Upon receipt of a Confirmation Letter* (not issued for EU/EFTA citizens) and arrival at GUT submit the following documents:
The entry qualification documents are accepted in the following languages: English / Polish.
Often you can get a suitable transcript from your school. If this is not the case, you will need official translations along with verified copies of the original.
If documents are submitted in other foreign language, they have to be sworn translated into Polish, and then legalized or apostilled.
You must take the original entry qualification documents along with you when you finally go to the university.
Original documents must be submitted + 1 paper copy upon arrival at GUT.
Before the submission of the application, it is required that the applicant will contact:
An interview will be held at the faculty recruitment center (you can apply for an online interview).
Courses focus on electrical and control engineering. The study program consists of four modules:
I. The fundamental lectures in the field of electrical and control engineering and more detailed lectures corresponding to the area of research;
II. Optional courses for developing of teaching skills to prepare for the performance of the academic profession and for developing social skills;
III. A fundamental introduction to modern approach to science, especially in engineering. The module also gives an insight how the scientific methods could be applied in electrical and control engineering. After the course the students should be able to carry on research projects and write a technical or scientific report;
IV. Conducting the laboratory exercises, project and similar activities for students as a practice in the department of electrical engineering or automatic control and robotics.
The graduates have the knowledge and skills in the fields of electrical engineering. The graduates are qualified to work as lecturers at University of Technology. They are prepared for scientific work. They can be employed in the research and development centers, industrial laboratories, design offices other centers.